SPECIFICATIONS

Brand Name: Sweetmile

Control Method: Knob

Gross Weight: 3.5kg/7.72lbs

High-concerned chemical: None

Interface Standard: G1/2"

Material: ABS, 304 Stainless Steel, 316 Stainless Steel

Mount Type: Wall Mounted, Floor Standing

Nominal Pressure: 0.75Mpa

Origin: Mainland China

Plug Type: EU Standard

Power Source: AC,Corded Electric

Process: Injection Mold

Product Size: 33*23*24cm/12.99*9*9.45in

Rated Capacity: 6L/1.59Gal

Rated Frequency: 50Hz

Rated Power: 1500W

Rated Voltage: 220V

Screen Type: LED

Start Water Flow: 0.4Mpa

Temperature Range: 0-65℃/32-149℉

Water Heating Time: 15-30min

Water Outlet/Inlet: Upper

Waterproof Grade: IPX4

Wire Cross Section: 1.5mm²

Application

It can be mounted on the wall or underneath the sink in your kitchen.

Specifications

Color: White

Material: ABS, 304 Stainless Steel, 316 Stainless Steel

Process: Injection Mold

Power Source: Corded Electric

Plug Type: EU Standard

Assembly Required: Yes

Mount Type: Wall Mounted, Floor Standing

Screen Type: LED

Control Method: Knob

Water Outlet/Inlet: Upper

Water Heating Time: 15-30min

Temperature Range: 0-65℃/32-149℉

Interface Standard: G1/2"

Wire Cross Section: 1.5mm²

Start Water Flow: 0.4Mpa

Rated Voltage: 220V

Rated Frequency: 50Hz

Rated Power: 1500W

Rated Capacity: 6L/1.59Gal

Nominal Pressure: 0.75Mpa

Waterproof Grade: IPX4

Power Cord Length: 1-1.3m/3.28-4.27ft

Product Size: 33*23*24cm/12.99*9*9.45in

Packaging Size: 42*29*20cm/16.54*11.42*7.87in

Gross Weight: 3.5kg/7.72lbs

Package Included

1*Electric Water Heater

1*Safety Relief Valve

1*Hose

1*English Manual           

Other Needed Accessories

Notes

1. Please check the size carefully before ordering. Please note that the product is not suitable for showering.

2. Please read the operating manual completely before use. And pay particular attention to the safety instructions included.

3. Installation conditions: 1) Tap water with a water pressure of 0.4MPA; 2) Hot and cold faucets; 3) The installation position of the water tower for water supply should have a height difference of more than 5m/16.4ft from the water tower. There must be a floor drain with sufficient drainage capacity near the installation site, and the installation space should be sufficient. The product is for the top water outlet, so please install it under the faucet.

4. Please note that the product itself can not adjust the water temperature, the product needs to be used with a hot and cold mixer faucet to install and adjust the temperature. It is not recommended to use a single cold faucet. It is not recommended to use a one-way faucet, otherwise, the water temperature will be too high and may lead to scalding. The usage effect will also be poor.

5. Please do not install this product horizontally, flat, or upside down. The water outlet can only be parallel to the wall. The installation position should be close to the faucet and the water pipe you prepared should not be too long, otherwise, the hot water outlet will be slow. When installing the machine for the first time, it is necessary to first connect the water and then power it on. (Turn the mixed water faucet switch to the hot water side, when the air is exhausted and water is coming out, it means the water is full, then you can turn on the power.)

6. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.